[How to Trim Inside Corners of Wardrobe Edging]130

In the world of furniture manufacturing, precision and attention to detail are paramount. When it comes to wardrobe edging, ensuring a clean and seamless finish is essential. One of the most challenging aspects is trimming the inside corners, where two strips of edging meet. In this comprehensive guide, we will provide step-by-step instructions on how to achieve a professional-looking inside corner finish.

Step 1: Prepare Your Materials

Before you begin, gather the necessary materials:

Wardrobe edging strips
Miter saw or miter box
Tape measure
Pencil or marking tool
Sandpaper or sanding block
Adhesive (e.g., contact cement, wood glue)

Step 2: Measure and Mark the Corner

Using a tape measure, determine the length of the edging strips needed for each side of the corner. Mark the desired length on each strip with a pencil or marking tool.

Step 3: Cut the Edges at a 45-Degree Angle

Set up your miter saw or miter box at a 45-degree angle. Place one edge of the edging strip against the fence and carefully cut the strip at the marked length. Repeat this step for the other edge of the corner.

Step 4: Test Fit the Edges

Before applying any adhesive, dry-fit the edging strips together to ensure a snug fit. If necessary, adjust the angle of the cuts slightly with a sanding block or sandpaper.

Step 5: Apply Adhesive to the Edges

Using a brush or roller, apply a thin layer of adhesive to the inside surface of both mitered edges. Follow the manufacturer's instructions for the specific adhesive you are using.

Step 6: Join the Edges Together

Carefully align the mitered edges and press them together firmly. Use a rubber mallet or hand pressure to ensure a secure bond. Wipe away any excess adhesive that may squeeze out.

Step 7: Clamp the Corner

To reinforce the joint, use clamps to hold the edges firmly together. Apply even pressure on both sides of the corner and allow the adhesive to cure as per the manufacturer's instructions.

Step 8: Remove the Clamps and Trim the Excess

Once the adhesive has cured, remove the clamps. Use a sharp utility knife or flush trim saw to trim off any excess edging that extends past the corner.

Step 9: Sand and Finish the Corner

Sand the corner lightly with fine-grit sandpaper to smooth any rough edges or imperfections. If desired, apply a clear lacquer or sealant to protect the finish and enhance its durability.

By following these steps, you can achieve a clean and professional-looking inside corner finish on your wardrobe edging. With patience and precision, you can create high-quality furniture that will last for years to come.

2025-02-21

Previous：How to Measure Edging Strips for Wardrobe Furniture

Next：How to Achieve a Burr-Free Finish on Veneer Edge Banding