How to Repair Veneer Edge Banding on Panel Furniture52

Veneer edge banding is a thin layer of wood or other material that is applied to the edges of panel furniture to create a smooth, finished look. Over time, edge banding can become damaged or worn, which can detract from the appearance of the furniture. Fortunately, edge banding can be repaired relatively easily with a few simple tools and materials.

Materials needed:* New veneer edge banding
* Wood glue
* Clamps
* Sandpaper
* A sharp knife
* A hammer or mallet

Instructions:1. Remove the damaged edge banding. To do this, carefully score the edge banding with a sharp knife, then pry it off with a hammer or mallet. Be careful not to damage the underlying wood.
2. Apply wood glue to the edge of the furniture. Use a thin, even coat of glue.
3. Apply the new edge banding to the edge of the furniture. Align the edge banding carefully, then press it into place.
4. Clamp the edge banding in place. Use clamps to hold the edge banding securely while the glue dries.
5. Allow the glue to dry completely. This will typically take several hours.
6. Once the glue is dry, remove the clamps.
7. Sand the edge banding flush with the surface of the furniture. Use a fine-grit sandpaper to avoid scratching the furniture.
8. Enjoy your repaired furniture!

Tips:* If the damaged edge banding is very thin, you may need to apply two or more layers of new edge banding.
* If the damage is extensive, you may need to replace the entire piece of furniture.
* Edge banding can be repaired with a variety of materials, including wood, plastic, and metal. Choose a material that is compatible with the furniture and the desired look.
With a little care and attention, you can easily repair damaged edge banding on panel furniture and restore its original beauty.

2024-10-07

Previous：How to Apply Edge Banding with a Hot Melt Glue Gun

Next：How Much Do Furniture Edging Strips Cost Per Meter in Shenyang?