How to Apply Edge Banding to Moldings60

Edge banding is a thin strip of material that is applied to the edges of moldings to cover the unfinished wood and protect it from moisture and damage. It is available in a variety of materials, including wood, PVC, and metal, and can be applied using a variety of methods.

Apply Edge Banding with an Iron
Cut the edge banding to the desired length and shape.
Heat the iron to the setting recommended for the edge banding material.
Apply a thin layer of glue to the edge of the molding.
Place the edge banding on the molding and press it down with the iron.
Hold the iron on the edge banding for a few seconds, until the glue has melted and the edge banding has adhered to the molding.
Trim any excess edge banding with a sharp knife.

Apply Edge Banding with a Heat Gun
Cut the edge banding to the desired length and shape.
Heat the heat gun to the setting recommended for the edge banding material.
Apply a thin layer of glue to the edge of the molding.
Hold the edge banding against the molding and heat it with the heat gun until the glue melts and the edge banding adheres to the molding.
Hold the edge banding in place for a few seconds, until the glue has cooled and the edge banding is secure.
Trim any excess edge banding with a sharp knife.

Apply Edge Banding with a Banding Machine
Cut the edge banding to the desired length.
Apply a thin layer of glue to the edge of the molding.
Insert the edge banding into the banding machine and adjust the settings.
Feed the molding through the banding machine and allow the machine to apply the edge banding.
Trim any excess edge banding with a sharp knife.

Once the edge banding has been applied, it should be sanded and finished to match the rest of the molding. This will help to protect the edge banding from damage and give the molding a professional-looking finish.

Here are some additional tips for applying edge banding to moldings:
Use a sharp knife to cut the edge banding. This will help to prevent the edge banding from tearing or fraying.
Apply a thin layer of glue to the edge of the molding. Too much glue will make the edge banding difficult to apply and may cause it to bleed out.
Hold the edge banding in place for a few seconds after applying it to the molding. This will help the glue to set and the edge banding to adhere properly.
Sand and finish the edge banding to match the rest of the molding. This will help to protect the edge banding from damage and give the molding a professional-looking finish.

2024-12-18

Previous：How to Re-Edge Cabinet Veneer Strips When They Fall Off

Next：Machine Edge Banding vs. Strip Edge Banding: Which Is Better?