How to Glue Edge Banding with Suanfeng Edge Bander163

Suanfeng Edge Bander is a professional edge banding machine that is widely used in the furniture industry. It is known for its high efficiency, precision, and ease of use. One of the most important aspects of edge banding is the adhesion of the edge banding strip to the substrate. In this article, we will provide a detailed guide on how to properly glue edge banding with Suanfeng Edge Bander.

Materials you will need:
Suanfeng Edge Bander
Edge banding strip
Wood glue
Applicator brush or roller
Clean cloth

Step 1: Preparing the edge banding strip

Before gluing the edge banding strip, it is important to prepare it properly. First, measure and cut the edge banding strip to the desired length. Then, apply a thin layer of wood glue to the back of the edge banding strip. Use an applicator brush or roller to ensure an even distribution of the glue.

Step 2: Applying the edge banding strip

Once the edge banding strip is prepared, it is ready to be applied to the substrate. Align the edge banding strip with the edge of the substrate and press it firmly into place. Use a clean cloth to remove any excess glue that may squeeze out from the sides.

Step 3: Activating the edge bander

After the edge banding strip is applied, it is time to activate the edge bander. Turn on the edge bander and set the temperature and speed according to the manufacturer's instructions. The temperature should be high enough to activate the glue, but not so high that it scorches the edge banding strip or the substrate.

Step 4: Pressing the edge banding

Once the edge bander is activated, press the edge banding strip firmly against the substrate. The pressure applied will help to activate the glue and form a strong bond between the edge banding strip and the substrate. Hold the pressure for the recommended amount of time according to the manufacturer's instructions.

Step 5: Trimming the excess edge banding

After the edge banding is pressed, it is time to trim the excess edge banding strip. Use a sharp utility knife or a trimming tool to carefully trim the excess edge banding strip flush with the surface of the substrate. Be careful not to damage the edge banding strip or the substrate.

Step 6: Finishing the edge banding

Once the excess edge banding is trimmed, it is time to finish the edge banding. This can be done by sanding the edge banding strip flush with the surface of the substrate. Use a fine-grit sandpaper and sand in the direction of the grain. Be careful not to over-sand the edge banding strip.

By following these steps, you can properly glue edge banding with Suanfeng Edge Bander. With its high efficiency, precision, and ease of use, Suanfeng Edge Bander is an excellent choice for furniture manufacturers and woodworking professionals.

2024-12-18

Previous：How Do Different Edging Methods Affect Furniture Appearance?

Next：Can Edging Strips Used for Stapling Be Changed to Machine Edging?