How to Edge Band the Inner Opening of Cabinet Doors267

As a leading Chinese furniture edge banding factory, we often encounter inquiries about how to edge band the inner opening of cabinet doors. This can be a tricky task, but with the right tools and techniques, it can be done relatively easily. In this guide, we will walk you through the steps on how to edge band the inner opening of cabinet doors using a manual edge bander.

Materials you will need:* Cabinet door
* Edge banding material
* Manual edge bander
* Hot melt adhesive
* Trim router
* Sandpaper
* Clamps

Steps:1. Prepare the cabinet door and edge banding material. Cut the edge banding material to the desired length and apply hot melt adhesive to the back of the material.
2. Align the edge banding material with the inner opening of the cabinet door. Use clamps to hold the material in place.
3. Use the manual edge bander to apply pressure to the edge banding material. This will melt the adhesive and bond the material to the cabinet door.
4. Trim the excess edge banding material. Use a trim router to trim the excess material flush with the surface of the cabinet door.
5. Sand the edge band. Use sandpaper to smooth out the edge band and remove any sharp edges.

Tips:* Use a sharp blade on the trim router to prevent chipping or tearing the edge banding material.
* Be careful not to apply too much pressure when using the manual edge bander. Too much pressure can cause the edge banding material to buckle or tear.
* If you are having trouble getting the edge banding material to adhere to the cabinet door, try using a heat gun to soften the adhesive.
* Once the edge band is applied, you can stain or paint it to match the rest of the cabinet door.

By following these steps, you can easily edge band the inner opening of cabinet doors and achieve a professional-looking finish.

2024-12-19

Previous：How to Edge Band an 18mm Board with a 19mm Edging Tape

Next：What Materials Can Be Edged with EVA Edge Banding?