How to Edge Band an 18mm Board with a 19mm Edging Tape65

Introduction:

Edge banding is an essential process in furniture making, as it provides a clean and finished look to the edges of panels. When edging an 18mm board, it is important to use a 19mm edging tape. This will ensure a flush and seamless finish. In this article, we will provide a step-by-step guide on how to successfully edge band an 18mm board with a 19mm edging tape using a hot air edge banding machine.

Materials and Equipment:
18mm board
19mm edging tape (matching the color and texture of the board)
Hot air edge banding machine
Trimmer
Sandpaper
Safety glasses
Dust mask

Step 1: Prepare the Edge of the Board:

Ensure that the edge of the board is clean and free of any debris. Remove any existing edging tape or glue residue. Sand the edge slightly to create a smooth surface for the tape to adhere to.

Step 2: Set Up the Edge Banding Machine:

Adjust the temperature and feed speed of the edge banding machine according to the manufacturer's recommendations. For 19mm edging tape, the recommended temperature is typically around 200-230°C (392-446°F). Set the feed speed to a moderate pace, ensuring the tape is applied evenly.

Step 3: Apply the Edging Tape:

Hold the edging tape against the edge of the board and guide it into the machine. The machine will apply heat to the adhesive on the tape, melting it. The melted adhesive will bond the tape to the edge of the board as it passes through the machine.

Step 4: Trim the Excess Edging Tape:

Once the edging tape is applied, use a trimmer to remove any excess material. Trim the tape flush with the surface of the board on both sides. Be careful not to damage the board or the edging tape.

Step 5: Sand and Finish:

Sand the edges to smooth out any roughness or unevenness. Use fine sandpaper to avoid scratching the surface. If desired, apply a clear finish to the edges to protect them and enhance their appearance.

Tips:
Always wear safety glasses and a dust mask when operating the edge banding machine.
Test the machine settings on a scrap piece of board before edging the actual panel to ensure optimal results.
Keep the machine clean by removing any excess adhesive or dust.
Use a sharp trimmer blade to achieve clean and precise cuts.
Avoid applying too much pressure when trimming the edging tape, as this can damage the material.

2024-12-19

Previous：How to Edge Banding for Narrow Boards: A Comprehensive Visual Guide

Next：How to Edge Band the Inner Opening of Cabinet Doors