Do Edge Bands Need to Seal All Edges?103

##
Edge banding is an essential part of furniture making, as it provides a smooth, finished look to the edges of furniture panels. Edge banding also protects the edges from moisture and wear, making them more durable and long-lasting.

However, there is some debate over whether or not all edges of a furniture panel need to be banded. Some people argue that only the visible edges need to be banded, while others believe that all edges should be banded for maximum protection and durability.

There are several factors to consider when deciding whether or not to band all edges of a furniture panel. One factor is the type of furniture. Furniture that is used in high-traffic areas, such as kitchens and bathrooms, is more likely to experience wear and tear, so it is important to band all edges of these panels to protect them from moisture and damage.

Another factor to consider is the type of edge banding material. Some edge banding materials, such as PVC and melamine, are more durable than others, so they can provide better protection for the edges of furniture panels. If you are using a less durable edge banding material, it is important to band all edges of the panel to ensure maximum protection.

Finally, you should also consider the cost of edge banding. Edge banding can be expensive, so it is important to weigh the cost against the benefits of banding all edges of a furniture panel. If you are on a budget, you may want to consider banding only the visible edges of the panel.

Ultimately, the decision of whether or not to band all edges of a furniture panel is up to you. However, by considering the factors discussed above, you can make an informed decision that will help you create beautiful, durable furniture that will last for years to come.Additional Tips for Edge Banding:
* Use a sharp utility knife to cut the edge banding to the correct size.
* Apply a thin layer of glue to the edge of the furniture panel and to the back of the edge banding.
* Press the edge banding onto the panel and use a rubber mallet to tap it into place.
* Trim any excess edge banding with a utility knife.
* Sand the edge banding flush with the surface of the panel.

2024-12-19

---

Previous：How to Use a Laser Edging Strip Manually

Next：Hot Melt Glue Edgebanding vs. PUR Edgebanding: Are They the Same?